Basement Waterproofing Before & After Photos

A homeowner in Waseca, MN, had water leaking into his basement and cracks forming along the walls which concerned him about the potential damage to his home. He quickly began searching for services in the area and came upon American Waterworks through our website. After browsing our Before and After photos of Waterproofing Basements and Foundation Repair, he contacted us to claim his FREE estimate and scheduled a date with one of our experts.

Our Design Specialist, Lance S., arrived at the home and conducted a thorough inspection of the basement. He explained that one of the causes of a wet basement is the "clay bowl" effect. When excavated soil is replaced around a completed foundation, it isn't as dense and tightly packed as undisturbed soil further away. As a result, when it rains, water collects in the soil, putting pressure on foundation walls and causing it to crack. Water then forces itself through the cracks into the basement. To address this issue, Lance recommended our GeoLock anchors, CarbonArmor, WaterGuard, TripleSafe Sump Pump, IceGuard, and CleanSpace. The homeowner was happy to proceed, and Lance's design was sent to our Foreman, Diego B. 

Our Foreman, Jesus C., and Diego B., and their crew arrived at the home on separate days for the installations. To waterproof the basement, the crew installed 127 feet of WaterGuard. These are placed around the perimeter of the basement by hammering into the floor. Next, rocks are placed in the holes, and the WaterGuard is positioned on the top, connecting to the sump pump. Once set, the concrete is poured back on top of the installation. The TripleSafe sump pump provides three levels of protection for your basement. One pump is installed at the lowest level, capable of discharging 2,200 gallons of water per hour. The second pump is installed a little bit higher to act as a backup if the primary pump fails or is overwhelmed with heavy water. The third pump is installed at the highest level in case of power outages. Additionally, two IceGuards were installed outside the home to eject water away from the foundation. Our IceGuards are designed not to freeze during cold temperatures, unlike traditional discharge lines. The crew also installed CleanSpace, a plastic wall vapor barrier, on the walls to prevent mold growth. In total, they installed a total of 127 feet of CleanSpace. For foundation repair, the crew installed 18 GeoLock wall anchors. The anchors are installed by digging a hole in undisturbed soil several feet away from the foundation. The first GeoLock anchor is placed inside and attached to the interior wall, with both anchors connected by a small steel pole. The GeoLocks permanently stabilize the foundation walls and can be adjusted to straighten the walls over time. Finally, 7 CarbonArmors were installed on the remaining walls. The installation process involves cleaning the walls, applying epoxy, and securing the CarbonArmor straps on top. After everything was installed, the crew cleaned up their equipment and left the home, leaving the homeowner with peace of mind.

Now, our customer no longer has to worry about his basement! Are you experiencing similar issues? Click HERE to claim your FREE estimate!

A Minneapolis, MN, homeowner was dealing with a leaky basement. Each time it rained, the homeowner was left with leaky basement walls and standing water. She no longer wanted to deal with the nuisance, so she began to look for Minneapolis basement waterproofing. After hours of combing through results, she found our website and decided to sign up for her FREE estimate. Several weeks later, Eric H, one of our Design Specialists, headed out to the property to see what could be done. 

Once Eric finished his thorough inspection, he was ready to make his recommendations. First, Eric recommended the use of our CleanSpace. He explained that CleanSpace is a 100% waterproof tarp-like material that gets applied directly to the walls. It works to catch water entering through porous holes or cracks in the wall, directing it downward and into a perimeter drain. The basement lacked a drainage system, so Eric wanted to use our WaterGuard. Our WaterGuard is a French drain that gets applied below the basement floor, but atop the foundation footing, keeping it out of the "mud zone" where other drains tend to clog. The WaterGuard catches water running down the wall from the CleanSpace, as well as any water entering through the floor, and gives it a channel to flow to the appropriate disposal site, which in this case, was an already placed sump pump. The homeowner liked the sound of our products working hand in hand and decided to schedule her job for several weeks later.

On the day of the installation, our Foreman, Kiko, led his team through a flawless installation. Now, our customer can rest easy knowing her water intrusion issue has a reliable solution! 

Do you have a leaky basement? Click HERE for your FREE estimate! 

A new homeowner from Minneapolis, MN, went down to her basement after a particularly hard rain and was shocked to notice that she had standing water in several parts of her basement. Frazzled by her discovery, she quickly took to the internet to search for Minneapolis basement waterproofing. After a few hours of combing through different websites, she landed on our page. She was thoroughly impressed by our basement waterproofing before and after images and decided to sign up for our FREE estimates. A few weeks later, our Design Specialist, Derek V, headed out to the home. After conducting his inspection, he met with the homeowner to discuss his findings. Derek wanted to use several of our products to complement each other and most importantly, to keep water off the basement floor. First, Derek recommended our CleanSpace vapor barrier be installed on the leaky walls. Derek explained that our CleanSpace is a 100% waterproof plastic vapor barrier that gets applied directly to unfinished basement walls, and works to direct water entering through the wall, downward, and into a perimeter drain, which, in this case, Derek wanted to be our WaterGuard. This unique French drain gets installed below the basement floor slab but on top of the foundation footing, keeping it out of the "mud zone" where similar drains tend to clog. Because the CleanSpace runs into the WaterGuard, it collects water entering from the wall, and small porous cracks or holes in the floor, giving the water a channel to flow to the appropriate disposal site. Derek noticed the lack of drainage from the basement itself and urged the homeowner to add one because of the large amount of water entering the space. Derek recommended our SuperSump sump pump, an effective and economical solution. This sump is engineered to help keep the basement dry and healthy for extended periods of time, even in times of heavy water intrusion. The SuperSump® includes a powerful Zoeller® ⅓ horsepower cast-iron sump pump, capable of pumping 2,220 gallons of water per hour at an 8-foot head out of your basement. Derek went on to say that the SuperSump can be installed with the optional UltraSump battery backup, which is designed to provide reliable, high-volume pumping capability when the electrical grid goes down. After Derek and the homeowner discussed options, she was thrilled to know that our solution would keep her basement dry and healthy for years to come and decided to schedule the installation for several weeks later. 

On the day of the project, our Foreman, Kiko P, led his team through the installation with a breeze. When they finished, they installed 14ft of WaterGuard, 1 SuperSump Sump Pump, 1 UltraSump battery backup, and 24 ft of CleanSpace throughout the basement. Now, our customer can enjoy her largest investment knowing that it is properly protected from unwanted water! 

Do you have a leaky basement that needs addressing? Click HERE for your FREE estimate! 

Following heavy rainfall, a homeowner in Calmar, IA, knew they needed to inspect their basement for any damage. The homeowner went to the basement and made a startling discovery, several wet spots throughout the basement. Knowing this would only worsen, the homeowner knew they needed to find a lasting solution. Unsure of the cause, the homeowner began looking into basement waterproofing companies near Calmar, IA. Our stellar reviews and ratings immediately caught the homeowner's attention, so they went to our website and signed up for their FREE estimate. Once the estimate was set, we sent one of our Iowa-based Design Specialists, Brady, to the home to begin the estimate appointment. During his investigation, Brady found that several areas in the basement where water was sneaking in. Brady completed the estimate appointment and was able to provide the homeowner with a solution to the issue. After hearing Brady's proposal, the homeowner knew this was their best option, so they agreed. Brady sent the plans to our Office, then they passed the plans along to our Foreman, Juan, and his crew. Once they received the proposal, Juan and his crew traveled to Calmar and began the waterproofing project. First, Juan and his crew started by installing WaterGuard around the perimeter of the basement. Next, the crew took out the old sump pump and replaced it with the SuperSump+. Once the SuperSump+ was secured, the crew dug a feedline to connect the WaterGuard to the new sump. Finally, the crew attached CleanSpace to the unfinished basement walls. Juan and his crew wrapped up the project and left the basement better than they arrived. The homeowner was impressed with the transformation done by the crew. American Waterworks is happy to transform its customer's basements and eliminate any water intrusion issues. 

A homeowner from Lake City, MN, had noticed her basement walls were leaking after heavy rain in the area. She was concerned about what leaking walls could mean for her house, so she immediately began to search for 'interior basement waterproofing near me' and quickly found our website. She signed up for her FREE estimate, and several weeks later, our Design Specialist, Darin S, headed out to the home. 

Upon his arrival, Darin got right to work assessing the space. Once he finished, he was ready to meet with the homeowner to deliver recommendations. Darin began by saying that the homeowner did the right thing by seeking a professional's help. He explained that water intrusion issues are often simpler to tackle when they're first noticed versus years down the road. Darin wanted a comprehensive system for this basement to ensure that unwanted water was a thing of the past. First, he recommended the installation of our CleanSpace vapor barrier. CleanSpace is a 100% waterproof tarp-like material that gets installed directly onto unfinished basement walls, acting to catch water entering through small cracks and holes in the foundation, directing it downward and into our WaterGuard system. This unique French drain gets installed below the basement floor but atop the footing of the foundation, keeping it out of the 'mud zone' where similar drains tend to clog. This drain works to trap water entering from the CleanSpace, as well as any water coming up through holes in the floor, giving it a channel to flow freely to the appropriate disposal site. Darin noted that the basement lacked a means of disposing of unwanted water, so he recommended our SuperSump Plus, an effective yet economical decision for combating unwanted water. The homeowner loved the idea of our products working together to keep the basement dry and signed on the spot. 

When the day of the installation eventually rolled around, our Foreman, Lane S, and his team arrived bright and early to complete the project. In the end, they successfully installed 95ft of WaterGuard, 79ft of CleanSpace, and 1 SuperSump Plus sump pump. Now, our customer can enjoy the rain, confidently knowing that her basement has the best line of defense against water!